AVA Series (10 kHz – 30 MHz)
Up to 4 Inputs and 10 Outputs – According to Customer Needs
No Restriction of Antenna Selection
Description
The AVA 10 is available in various configurations with 1 – 4 inputs and up to 10 outputs. It covers the frequency range from 10 kHz to 30 MHz.
The units are designed for integration into 19-inch racks. They require only 2 HU so its small footprint allows for flexible integration into the application environment.
The AVA features
- No restriction of antenna selection
- Number of inputs and outputs configurable
- Fast input to output switching
- Switchable input protection (auto – 0 dB – 6 dB – 20 dB)
- Special preamplifiers available for limitation of frequency range or passive bypass
- Watchdog for active antennas, preamplifiers and channel amplifiers
An integrated control unit controls the antenna distributor AVA. Local control from the front panel, remote operation through RS232/RS422 interface or Ethernet LAN interface 10/100M is supported.
Customer specific requirements can be considered.
Technical Data
| Dimension slide-in unit (w x h x d) | 19″ x 2 HU x 360 mm |
| Weight | 6,5 kg |
| Colour of front panel | RAL 7035 (light grey) |
| Labeling | English |
| Mains supply | 85 – 264 Vac, 50 – 60 Hz |
| Power consumption | 45 VA |
| Battery supply (option) | 18 – 36 Vdc, max. 3,5 A (ground free) |
| Ambient temperature | -10°…+60°C (IEC 60945) |
| Storage temperature | -20°…+70°C (IEC 60945) |
| Relative Humidity | 95%, +20 – +55°C (IEC 60945) |
| EMC | Immunity EN 61000-6-2 Emission EN 61000-6-3 |
| Vibration | EN 60945 (2003) |
| MTBF | > 21.000 h (unit fully equipped) |
| MTTR | 0,5 h (replacement of sub units) |
| Antenna inputs | max. 4 (N socket) * |
| Input impedance | 50 Ω, VSWR ≤ 1,4 |
| Maximum signal level CW | 37 dBm (5W) |
| Input protection | 2 kV 50 μs |
| Receiver outputs | max. 10 (BNC socket) * |
| Output impedance | 50 Ω, VSWR ≤ 1,5 |
| Frequency range | max. 0,01 – 30 MHz |
| Gain (0,03 – 30 MHz) | 0,5 … 2,5 dB |
| Noise figure | 8 dB |
| Intercept point IPOP2 | 66 dBm |
| Intercept point IPOP3 | 37 dBm |
| 1 dB gain compression | 16 dBm |
| Decoupling between 2 outputs | 65 dB |
| Decoupling between output and input | 90 dB |
| Cross talk between two inputs | 36 dB |
| Remote control interface | RS 232 / RS 422 or Network LAN |
| Switching time | typ. 1 ms |
Notas
* depends on configuration
Data given without tolerance are typical values.
Design and specification are subject to change without prior notice, errors excepted.
Product specification 2_1_5, © AAS GmbH
Options
The AVA 10 can be configured with these options according to customer needs:
- output sockets typ N instead of BNC
- addional power supply 18-36 Vdc (ground free)
- with automatic switch-over in case of mains failure
- Remote control Ethernet LAN 10/100 interface instead of RS 232 / RS 422 interface
- Front panel with special varnish according to customer specification
Type Designation (Configuration)
The type designation of the AVA 10 is AVA 10 X1 – X2 – X3 – X4 – X5
| X1 |
Option BNC = BNC sockets |
| X2 |
Configuration L = 0,01 – 30 MHz (standard) |
| X3 |
Configuration H = 0,01 – 30 MHz (standard) |
| X4 |
Option DC = power supply unit with additional input for emergency operation |
| X5 |
Option LAN = Unit is equipped with Ethernet LAN 10/100 interface instead of |
The following examples shall help to find the correct type designation.
Assuming an AVA 10 with 3 inputs, 6 BNC outputs, supply voltage 230 Vac and RS232
interface shall be the need, the type designation is
AVA 10 B – 3L – 6H
Assuming an AVA 10 with 4 inputs, 10 N outputs, supply voltage 230 Vac and 18-36 Vdc, remote control through the LAN interface and input 1 shall have a passive bypass, the type designation is
AVA 10 N – 1L1 – 3L – 10H – DC – LAN
| Designation | Type | Part No. | Comentario |
| Preamplifier | PA L | 00-08-79-35-00 | |
| Preamplifier | PA L1 | 00-08-79-36-00 | passive bypass for input 1 |
| Channel Amplifier | CA H | 00-08-76-12-80 | |
| Motherboard AVA | MB AVA | 00-28-23-31-80 | |
| Control Unit | CU A | 00-28-05-01-80 | |
| Display Unit | DU B | 00-08-98-22-80 | |
| Remote Control Interface | LAN A | 00-28-05-03-80 | |
| Switch Board | SB B | 00-08-98-41-80 | |
| Power Supply | PS E | 00-08-74-10-00 | Option DC |
| Power Supply | PS E1 | 00-08-74-11-00 | standard AC power supply |
| Fuse | 5,0 AT/250V | E/0046 |
ES 
EN 
DE